Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Catalyst 2960S for IPTV backbone ?

Hello,

we have Catalysts 2960S for switching in our Wireless high capacity backbone network. As agregation switch we are using 3560x.

I just need to know, if are these 2960S good solution for igmp snooping for whole IPTV stream. It put only a range from backbone and put out on another port. But just specified multicast addresses.

Imput will be 239.128.0.10 to 239.128.0.20 on Gi 0/1

Output wil be 239.128.0.10 - 15 on Gi 0/24

IPTV will be separated on different VLAN for eg VLAN 20

Is needed any priorization configured od switches?

The capacity for IPTV is around 500 mbps

Thank you very much!

BR

dave

  • LAN Switching and Routing
Everyone's tags (5)
4 REPLIES
Hall of Fame Super Gold

Catalyst 2960S for IPTV backbone ?

The capacity for IPTV is around 500 mbps

I presume your uplink is 10Gb?

New Member

Catalyst 2960S for IPTV backbone ?

No, my uplink or radio network is 1 gig only. 2960S doesnt support 10 gig as i know.

Hall of Fame Super Gold

Catalyst 2960S for IPTV backbone ?

2960S comes in two flavours:  The plain has 1 Gb uplink and the "D" series has 1 Gb or 10 Gb uplink.

You may want to etherchannel your uplinks.  A single 1Gb uplink, in my humble opinion, will not be enough.

New Member

Catalyst 2960S for IPTV backbone ?

Thank you !

in bacbone uplink are 2 Vlans.

VLAN 20 - IPTV = 500 Mbit

VLAN 80 - NET = 200 Mbit

I hope it is enough

Uplink port is Gi 0/1

Downlink port for IPTV  is gi 0/24 with 300 Mbit IPTV traffic

1097
Views
0
Helpful
4
Replies