Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Catalyst 3350 Switch

When I power up my Catalyst 3550 switch, it boots up and shows "switch:" prompt. and it takes no command afterwards. I wonder what command prompt is "switch:". Please help.

3 REPLIES

Re: Catalyst 3350 Switch

This means the switch has NO configuration in it.

You need to start from the begining - read the below:-

http://www.cisco.com/en/US/docs/switches/lan/catalyst3550/software/release/12.2_25_see/configuration/guide/swcli.html

HTH>

Silver

Re: Catalyst 3350 Switch

Re: Catalyst 3350 Switch

That sounds like you have no IOS on the either.

Try the following:-

flash_init

load_helper

dir flash:

if there is an image in there boot from it

deja vu

if not copy one over. The complete procedure is here:

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

1256
Views
0
Helpful
3
Replies
CreatePlease to create content