Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Catalyst 3550 IPV6?

I upgraded a couple of 3550's to the latest 12.2(44)SE2 IP Services code recently and noticed IPV6 commands were available. I thought they might be visible but not accepted however they are accepted and when it is globally enabled (ipv6 unicast-routing) and IPV6 addresses are configured on interfaces I get an IPV6 routing table. I am pretty sure there was nothing in the release notes about IPV6, so is this a mistake or has IPV6 been added to the Catalyst 3550 (which is EOL).

Andy

1 REPLY
Hall of Fame Super Bronze

Re: Catalyst 3550 IPV6?

One of those things when software releases are shared among different platforms.

I recommend disabling IPv6 on that system if it's used on production as it is running in software, not hardware.

The switch's SDM template has no allocation for IPv6 routes.

HTH,

__

Edison.

2187
Views
5
Helpful
1
Replies