We are trying to connect a fiber port from a 3560 Switch to a HP ProCurve 8000 switch but I am not getting any activity on either port. I know both work when connected to the same HP manufacturer switch on both sides but I can't make them talk to each other. (Cisco to HP NO), (HP to HP YES). I am new with the Cisco switches but I figured they would work regardless of the device. Any thoughts? The fiber tests fine. Does the Cisco fiber port need to be enabled?
We have a site that has 20 users and a "remote" site that is about 200 Meters from the central server room with a 3560 with 1 Vlans (Voice and Computers) and is cabled with 6 strands of fiber. This remote area will only have 1 phone and it seems like a expensive cost to add an 8 or 24 port switch. We thought we could connect an additional phone via the Gigabit port and use a Fiber to Ethernet converter to run a 7940 phone. We tried connecting the Gbic connector of the Catalyst to the HP Gigabit (already have so a cost savings) fiber connector but there is no link light.
My thoughts are.
1. The gigabit port on the Catalyst isn't enabled?
2. The gigabit connector does not like the HP Fiber connector?
3. Will the Fiber to Ethernet work for a single phone?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.