Re: Catalyst 3560 PoE Port ASIC Port Loopback Test Issue
This is the wrong forum to post to for this issue but I can still give you insight. Basically when the switch is booting it's going through Power On Self Test (POST). The failures you're seeing basically mean this section of switch ports which are connected to an ASIC are not functional and or have failed. This is a physical hardware problem and can not be resolved. At this point you'll need to open up a TAC case for RMA.
Rate helpful posts
Blog - http://tripplehelix.net
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...