In the companywe switchedserver,the old serverwasWindowsServer 2003(DHCP, DNS, ActiveDirectory), we boughta new server withWindowsServer 2012R2 (DHCP, DNS, ActiveDirectory),we have 3networkSwitch's(Catalyst2960-S) and aCatalyst3560G,VLAN'sis 12,whichare configured,try toput the newWinServ2012R2server, userswho areconnected to the sameIPrangeas the server(10.1.0.x)have no problemin receivingan address,butthey arein allotherVLAN'scan notobtain avalidIPreceivethe erroneousIP (169.278.xx),what is itI'm doing wrongon the new serverormissinginCiscoSwitch'slsochange?
Users in the same vlan will be able to get IP address from the DHCP server because DHCP messages are broadcast whereas for users in the different vlans need " IP helper address" to be configured on the gateway/L3 vlan interface, so that the dhcp broadcast request can be sent to DHCP server.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...