First here is sh run and there is current configuration.
ip policy route-map DisasterRecovery is not shown in configuration and in sh ip policy command.
It is not possible to put ip policy command on gi interfaces!
At the end, I configured again ip policy command on interface vlan, it is permitted, but cann't see on configuration.
ip address 10.A.64.1 255.255.255.0 <----- NO ip policy command
ip local policy route-map DisasterRecovery
ip access-list extended DisasterRecovery
permit ip 10.A.64.0 0.0.0.255 10.B.64.0 0.0.0.255
permit ip 10.A.65.0 0.0.0.255 10.B.65.0 0.0.0.255
route-map DisasterRecovery permit 10
match ip address DisasterRecovery
set ip next-hop 10.A.60.36
route-map DisasterRecovery permit 20
3750#sh ip policy Interface Route map local DisasterRecovery <----- NO ip DisasterRecovery policy 3750#sh ip access-lists Extended IP access list DisasterRecovery 10 permit ip 10.A.64.0 0.0.0.255 10.B.64.0 0.0.0.255 (15 matches) 20 permit ip 10.A.65.0 0.0.0.255 10.B.65.0 0.0.0.255 (10 matches) 3750#sh route-map DisasterRecovery route-map DisasterRecovery, permit, sequence 10 Match clauses: ip address (access-lists): DisasterRecovery Set clauses: ip next-hop 10.A.60.36 Policy routing matches: 25 packets, 2710 bytes<----- policy works route-map DisasterRecovery, permit, sequence 20 Match clauses: Set clauses: Policy routing matches: 191001 packets, 282764144 bytes 3750#conf t Enter configuration commands, one per line. End with CNTL/Z. 3750(config)#interf gi 1/0/15 3750(config-if)#ip ? Interface IP configuration subcommands: access-group Specify access control for packets admission Apply Network Admission Control arp Configure ARP features auth-proxy Apply authenticaton proxy device IP device tracking dhcp Configure DHCP parameters for this interface igmp IGMP interface commands verify verify vrf VPN Routing/Forwarding parameters on the interface
3750(config-if)#interf vlan 64 3750(config-if)#ip policy route-map DisasterRecovery <----- policy configured on vlan interface 3750(config-if)#end 3750#sh run interf vlan 64 Building configuration...
Current configuration : 82 bytes ! interface Vlan64 description SERVERI ip address 10.A.64.1 255.255.255.0 <----- NO ip policy command end
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...