Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Catalyst 4003 Error Message

I know this switch is out of life cycle, but I wanted to still find out what is the following message mean....

Port Security: DOT1X: authenticatorstate for port x/x is FORCE_AUTH

  • LAN Switching and Routing
1 REPLY
Hall of Fame Super Bronze

Re: Catalyst 4003 Error Message

You have configured 802.1x authentication. Not much I can tell you from that message.

I suggest reading the documentation on such service:

http://www.cisco.com/en/US/docs/switches/lan/catalyst4000/8.1/configuration/guide/8021x.html

Regards,

Edison

122
Views
0
Helpful
1
Replies