Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Catalyst 4006 Trunking Protocol

What is the Command to disable Dynamic Trunking Protocol on a Catalyst 4006 Switch? I thought it was #switchport mode access, But It will not accept the word Switch as part of a command. Any Ideas??

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: Catalyst 4006 Trunking Protocol

James

Are you runnning IOS or CatOS. If IOS then are you using this command in interface configuration mode ie.

4500(config)# int gi4/1

4500(config-if)# switchport mode access

Jon

2 REPLIES
Hall of Fame Super Blue

Re: Catalyst 4006 Trunking Protocol

James

Are you runnning IOS or CatOS. If IOS then are you using this command in interface configuration mode ie.

4500(config)# int gi4/1

4500(config-if)# switchport mode access

Jon

New Member

Re: Catalyst 4006 Trunking Protocol

Jon,

Thanks alot, that was right on the Money. The Tech I was working with did not go into the interface before entering the command.

107
Views
0
Helpful
2
Replies
CreatePlease to create content