Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

Catalyst 4503-E SFP compatibility

Hi,

I found out that the 4503 with Supervisor Engine II-Plus-TS supports the GLC-SC-MM SFP module. The problem is that I can't find it, looks like Cisco is not selling it anymore.

I found only this: GLC-SX-MM=

I the Cisco Gigabit Ethernet Transceiver Modules Compatibility Matrix

(http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_6981.html#wp130094)

it says that this SFP is only compatible with 4506 and others, not 4503.

What SFP module could I use on the 4503 and 2960 for Multimode fiber?

4 REPLIES
Hall of Fame Super Silver

Re: Catalyst 4503-E SFP compatibility

Hello Smail,

usually a = is added to replacement parts or as stand-alone products it should be the same SFP you are looking for

GLC-SX-MM=

1000BASE-SX SFP transceiver module for MMF, 850-nm wavelength

About devices: the table should discriminate about the type of supervisors for thr 4500 not the chassis model.

You should be fine.

Hope to help

Giuseppe

New Member

Re: Catalyst 4503-E SFP compatibility

The = is not a problem.

The problem is between these two SFPs

One is GLC-SC-MM and the other GLC-SX-MM

the difference is between SC and SX.

And that is that is causing me problems. I have to be sure that I order the right SFP for the Supervisor EngineII-Plus-TS

and 2960 TC-L and 2960 PC-L.

Hall of Fame Super Gold

Re: Catalyst 4503-E SFP compatibility

GLC-SC-MM (Gigabit Ethernet SFP, LC connector, SX transceiver) is for the 4500 Series Supervisor Engine II-Plus-TS. Have you tried inserting a GLC-SX-MM in to see if it will work?

New Member

Re: Catalyst 4503-E SFP compatibility

Yeah I found it in the Dynamic Configuration Tool, so it is officially supported.

601
Views
0
Helpful
4
Replies