Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Catalyst 4506 logging

Hi all.

I'm having a strange problem on my cat 4506. I only use logging buffered debugging but when i issue 'show logg' i cannot see changing in interface status. If i plug a cable into a port, i expect a new log that show me that the interface (for example) gi2/1 goes up and vice-virsa if i unplug the cable but none.

Can you give me a hint about this problem?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Catalyst 4506 logging

R1(config)#logging event link-status

1 REPLY

Re: Catalyst 4506 logging

R1(config)#logging event link-status

113
Views
0
Helpful
1
Replies