I have two 4507R with redundant Supervisor V 10G cards, both switches are linked with an etherchannel.
This strange issue we are experiencing consists of one of our switches getting "frezzed", you can access it via local console, all basic processes seem to be running ok (cdp, stp, etc), interfaces are linked up, but the switch is not forwarding or receiving any packets.
This failure occurs occasionaly, and we could not get any reasonable diagnostic or solution rather than rebooting it.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...