I have 6513 CatOs switch with routing module on it. When I traceroute to one of my server from outside network,I found considerably more time from the IP address a VLAN interface on MSFC. So, I just wanted to see why it taking so much time. Then I installed and configure Netflow analyser on the the swtich but unable to point the spcific interface.
Is there any way to figure out weather the IP interface on MSFC is droping packets, or some any other problems with this interface
please help and let me know for problem explaination
2. Well, Yes, the interface in vlan 12 is connected with a 7200 router from where packet goes to internet cloud. When i traceroute to one of my server from outside, in 7200 router hope, delay is 30 ms but then after the delay is more like 60, and from the destination ( a inside server) even more like 160. But When i trace route the same sever from internal network, it is not more than 1 ms.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...