Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Catalyst 6500 - Sending commands to module

Hi,

Is it possible to send commands from Cat 6500 console into one of the connected modules such as FWSM.

For e.g. if I have no user defined on FWSM with privilege level 15, can I create a user with level 15 on FWSM via the Cat6500 console (i.e. without logging into FWSM as I don't have high privilege user).

Thanks.

3 REPLIES
Hall of Fame Super Silver

Re: Catalyst 6500 - Sending commands to module

Hello,

can you access the FSWM with

session slot fwsm_slot proc 1 ?

otherwise you need to use the

switch console fwsm_slot

command from supervisor console to access FWSM console

Hope to help

Giuseppe

Community Member

Re: Catalyst 6500 - Sending commands to module

Hi Giuseppe,

My query was if there is any way to modify FWSM config i.e. to create user, without sessioning into FWSM. Because I did some mistake on FWSM and locked myself out. I don't have a user with privilege level 15 on FWSM and to avoid password recovery, aaa command removal via module restart I want to know if there is any way I can recover from this situation.

Thanks

Hall of Fame Super Gold

Re: Catalyst 6500 - Sending commands to module

You may want to try using SNMP to modify your config.

130
Views
0
Helpful
3
Replies
CreatePlease to create content