cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
265
Views
0
Helpful
3
Replies

Catalyst 6509 boot looping

panchico123
Level 1
Level 1

I have a catalyst 6509-E that boot loops every 3 minutes.

Here are the SUP cards installed:

IN SLOT 6 NOT RECOGNISED 2.1  S/N: SAL094235DY  MODEL: WS-STP720 3B
sup other 2.3 HARDWARE REVISION

POLICY FEATURE CARD 3 IN SLOT 5 SAL0942313B REV 2.1 WS-F6KPFC3B
SAL09423ANX 2.3 WS-SUP720


SLOT 6 OTHER UNKNOWN - DAUGHTER POLICY 3 SAL1026SRT 2.3 WS-F6K-PFC3B

Is there any reason why this may be happening?

Any help appreciated.

Thank you

3 Replies 3

Reza Sharifi
Hall of Fame
Hall of Fame

If the sup is not being recognized by the hardware, you may have a faulty sup. You can also upgrade the IOS to eliminate any software issues the device may have.

HTH

Stephen Garbett
Level 1
Level 1

Minimum software requirements = 15.3(1)SY and above. Make sure your code is high enough.

Leo Laohoo
Hall of Fame
Hall of Fame

Console into the supervisor card.  Post the entire boot-up sequence.  We want to see the error message(s) generated.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco