Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Catalyst 6509 boot looping

I have a catalyst 6509-E that boot loops every 3 minutes.

Here are the SUP cards installed:

IN SLOT 6 NOT RECOGNISED 2.1  S/N: SAL094235DY  MODEL: WS-STP720 3B
sup other 2.3 HARDWARE REVISION

POLICY FEATURE CARD 3 IN SLOT 5 SAL0942313B REV 2.1 WS-F6KPFC3B
SAL09423ANX 2.3 WS-SUP720


SLOT 6 OTHER UNKNOWN - DAUGHTER POLICY 3 SAL1026SRT 2.3 WS-F6K-PFC3B

Is there any reason why this may be happening?

Any help appreciated.

Thank you

3 REPLIES
VIP Super Bronze

If the sup is not being

If the sup is not being recognized by the hardware, you may have a faulty sup. You can also upgrade the IOS to eliminate any software issues the device may have.

HTH

New Member

Minimum software requirements

Minimum software requirements = 15.3(1)SY and above. Make sure your code is high enough.

Hall of Fame Super Gold

Console into the supervisor

Console into the supervisor card.  Post the entire boot-up sequence.  We want to see the error message(s) generated.

29
Views
0
Helpful
3
Replies