Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Catalyst 6509 VSS dual-active recovery

Hi,

I'm using 2 6509 in VSS (version s72033-ipbasek9-mz.122-33.SXI2a.bin)

EV-SRGI1&2-6509-1#sh switch virtual role

Switch  Switch Status  Preempt    Priority  Role     Session ID
        Number         Oper(Conf) Oper(Conf)         Local  Remote
------------------------------------------------------------------
LOCAL    1     UP      FALSE(N )   110(110)  ACTIVE   0      0
REMOTE   2     UP      FALSE(N )   100(100)  STANDBY  2298   6693


In dual-active recovery mode: No
EV-SRGI1&2-6509-1#sh switch virtual dual-active fast-hello
Fast-hello dual-active detection enabled: Yes

Fast-hello dual-active interfaces:
Port       Local State    Peer Port    Remote State
---------------------------------------------------
Gi1/5/3    Link up        Gi2/5/3      Link up

Dual-active recovery mode works well except when the Inter-VSS link become operational again, the "recovery switch" never reloads to "stanby" because it indicates configuration has been changed and I have to save it before reloading

Is this normal ?

Thanks for help

1 REPLY
New Member

Re: Catalyst 6509 VSS dual-active recovery

The configuration guide states that the failed switch will not automatically reboot if there has been a change to the config which has not been saved.  Did you perform a cop run sta since the last change?

3623
Views
0
Helpful
1
Replies