Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Catalyst 7600 SUP-32

Hi all,

I have several Cisco 7609 with dual sup-32 installed, and from times to times when the switch suffer a power fail, the standby sup never come up, stays in rmon, the config/ios/bootvar are sync between the two sup-32. The only way to get the sup up and running is to manually perform a boot in rmon.

Does anyone has a similar problem ?

Thanks

2 REPLIES

Re: Catalyst 7600 SUP-32

can you check if your register number set correctly on both MSFC and SP.

Silver

Re: Catalyst 7600 SUP-32

Yes, use a "remote command switch show ver" and check the config-register of the SP

For the standby then you need to do a failover (or wait) and then check it out

304
Views
0
Helpful
2
Replies
CreatePlease to create content