Catalyst Express 500 not saving configuration from /exec mode
I have some Express 500 switches that when I go into /exec mode and make a change to the port-security on one port and then the switch is powered off or loses power the change is gone. When I am done I do a copy run start and a wr mem. I looked to see if it is putting in the startup-config and it is in there. Any ideas of how can fix this? I have to make this change and I have had the same problem on a couple different ones.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...