I was trying to configure 500 series switch. my network is configured on 10.0.0.0 network. the switch is not alowing to enter an ip in the 10.0.0.0. the software version is 12.2 (25)FY. can anybody tell me how i can download the IOS from site. i purchase the switches from my local supplier , so i dont have an order no, and customer no information.
you cannot download any IOS, without sufficient priviledge on your CCO ID. If you do not have any access, the only way is to get hold of a cisco partner or systems integrator, and get their help in downloading this with/without cost.. Once you have downloaded the software, u need to do the following, to upgrade the software:
Once the new Cisco IOS version is downloaded, perform these steps to update the switch:
Open up the switch management GUI.
Click on Software Upgrade.
On the Software Upgrade screen, click on Browse and select the tar file downloaded from the Cisco web site.
Click on Upgrade.
Note: Wait for the upgrade process to complete. Do not use or close the browser session with the device manager, and do not access the device manager from another browser session.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...