Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Catalyst Express 500...

We are using these for your Access point. I have a 1252 access point pluged into a power injector (pwrinj4) then a cat 5 going to the switch. I cant seem to get Power over Ethernet to work.

The port does not light up or show any sings thats its up (the one connected to my power injector)

Any ideas guys? The web interface isnt much help for the switch.

1 REPLY

Re: Catalyst Express 500...

If you use the CE500's PoE alone (without the power injector) does the port comes up or the AP powers up? Without additional info, I can only offer the following:

Intelligent Power Management support is dependent on the version of software resident in the Cisco switch that is providing power to the access point. Each Cisco switch should be upgraded to support Intelligent Power Management. Until the software is upgraded, you can use your controller to configure the access point to operate with older switch software using these controller CLI commands:

1) config ap power pre-standard enable

where is the access point name on the controller

2) config ap power injector enable

(where is the access point name on the controller

and is the MAC address of the switch port to which the

access point is connected)

http://www.cisco.com/en/US/docs/wireless/access_point/1250/installation/guide/125h_c4.html

106
Views
0
Helpful
1
Replies