Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CatOS Error-Console

Hi NetPro,

does anyone knwo this ?

Error-1-Console> sh test 1

Diagnostic mode: complete (mode at next reset: complete)

Diagnostic failure action for SUP: offline (mode at next reset: offline)

Module 1 : 2-port 1000BaseX Supervisor

Network Management Processor (NMP) Status: (. = Pass, F = Fail, U = Untested)

ROM: . Flash-EEPROM: . Ser-EEPROM: . NVRAM: . EOBC Comm: F

Line Card Firmware Status for Module 1 : PASS

Port Status :

Ports 1 2

-----------

. .

GBIC Status :

Ports 1 2

-----------

N N

Line Card Diag Status for Module 1 (. = Pass, F = Fail, N = N/A, U = Untested)

Module 1

Earl IV Status :

NewLearnTest: F

IndexLearnTest: F

DontForwardTest: U

DontLearnTest: U

ConditionalLearnTest: F

BadBpduTest: U

TrapTest: U

MatchTest: U

PortSpanTest: U

CaptureTest: U

ProtocolMatchTest: U

ChannelTest: U

Loopback Status [Reported by Module 1] :

Ports 1 2

-----------

F F

your reply will be highly appreciated.

regards,

Jack

  • LAN Switching and Routing
1 REPLY

Re: CatOS Error-Console

Could you provide more info like "show module" "show system", this means hardware issues EOBC Comm: F see Table 5-106 in link bellow. Are there any other cards installed in the chasis preseting problems, I would suggest to open TAC case for this issue.

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/8.x/command/reference/sh_ti_tr.html

PLS rate any helpful posy if it helps

Rgds

Jorge

404
Views
3
Helpful
1
Replies
This widget could not be displayed.