Hi NetPro,
does anyone knwo this ?
Error-1-Console> sh test 1
Diagnostic mode: complete (mode at next reset: complete)
Diagnostic failure action for SUP: offline (mode at next reset: offline)
Module 1 : 2-port 1000BaseX Supervisor
Network Management Processor (NMP) Status: (. = Pass, F = Fail, U = Untested)
ROM: . Flash-EEPROM: . Ser-EEPROM: . NVRAM: . EOBC Comm: F
Line Card Firmware Status for Module 1 : PASS
Port Status :
Ports 1 2
-----------
. .
GBIC Status :
Ports 1 2
-----------
N N
Line Card Diag Status for Module 1 (. = Pass, F = Fail, N = N/A, U = Untested)
Module 1
Earl IV Status :
NewLearnTest: F
IndexLearnTest: F
DontForwardTest: U
DontLearnTest: U
ConditionalLearnTest: F
BadBpduTest: U
TrapTest: U
MatchTest: U
PortSpanTest: U
CaptureTest: U
ProtocolMatchTest: U
ChannelTest: U
Loopback Status [Reported by Module 1] :
Ports 1 2
-----------
F F
your reply will be highly appreciated.
regards,
Jack