Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

catOS Help on Mac-address-table command

Hi,

could anyone point me in the right direction. not too catOS savvy

I need to get the mac addresses and ip addresses off a few interfaces to which servers are connected to on a 6500 catOS switch. could point me to the commands i can issue to get these?

thanks!

2 REPLIES

catOS Help on Mac-address-table command

to get the mac address try using "sh cam dynamic [interface #]

Cisco Employee

catOS Help on Mac-address-table command

Hello Gerald,

the command listed by Mandlenkosi is correct, here is a further reference to it:

http://www.cisco.com/en/US/customer/docs/switches/lan/catalyst6500/catos/7.x/command/reference/sh_a_c.html#wp1028328

additionally, once you have the mac entry from the above command, you would need to find the ARP entries from the MSFC (if that is what you require as well).

HTH

Pronoy

3614
Views
0
Helpful
2
Replies