Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CatOS help

Hi,

I am trying to view the interface configs and vlan assignment for interfaces on a Catalyst 4006 with CatOS but I am unfamiliar with CatOS commands. Can someone point me in the right direction?

-Shikamaru

3 ACCEPTED SOLUTIONS

Accepted Solutions

Re: CatOS help

Hi Shikamaru,

Here is the command,

Switch> (enable) sh port 3/1

Check this link

http://www.cisco.com/warp/public/473/53.shtml#Show_Port_for_CatOS_and_Show_Interfaces_

Please rate if that helps !

Regards,

`JG

Hall of Fame Super Blue

Re: CatOS help

Hi

To view the mac address table in CatOS

"sh cam dynamic"

You can also put in specific ports, do a

"sh cam ?"

HTH

Jon

Hall of Fame Super Bronze

Re: CatOS help

Since CatOS only functions at Layer2, you will only be able to see arp entries from the VLAN the management interface (sc0) is part of.

The command is show arp.

6 REPLIES

Re: CatOS help

Hi Shikamaru,

Here is the command,

Switch> (enable) sh port 3/1

Check this link

http://www.cisco.com/warp/public/473/53.shtml#Show_Port_for_CatOS_and_Show_Interfaces_

Please rate if that helps !

Regards,

`JG

New Member

Re: CatOS help

Is there a way to see the MAC address table and ARP table in CatOS? I found a command that looks like it should give me the information (show port x/y), but it doesn't have any MAC addresses in it. I'd just like to know what IP addresses are connected to each interface.

-Shikamaru

Hall of Fame Super Blue

Re: CatOS help

Hi

To view the mac address table in CatOS

"sh cam dynamic"

You can also put in specific ports, do a

"sh cam ?"

HTH

Jon

New Member

Re: CatOS help

How do you view the arp table in CatOS?

-Shikamaru

Hall of Fame Super Bronze

Re: CatOS help

Since CatOS only functions at Layer2, you will only be able to see arp entries from the VLAN the management interface (sc0) is part of.

The command is show arp.

New Member

Re: CatOS help

Thank you all for your help, you have been very helpful.

-Shikamaru

1540
Views
0
Helpful
6
Replies