Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CATOS port disable dquestion...

For the output of

show port 5/20

...

Port Security Violation Shutdown-Time Age-Time Max-Addr Trap IfIndex

----- -------- --------- ------------- -------- -------- -------- -------

5/20 disabled shutdown 0 0 1 enabled 122

...

Shouldn't set port enable 5/20 enable it?

And if that doesnt shouldnt

set port enable 5/20

enable it? I run that command and it tells me the port is enabled, but I am still seeing it shutdown.

I have also tried disabling then enabling it, still shows shutdown.

Thx

2 REPLIES
Hall of Fame Super Blue

Re: CATOS port disable dquestion...

Hi

The "shutdown" part of your output is not referring to the port status. It is referring to the action that will be taken if there is a violation of port security. Note that whether you have port security enabled or not it will still show this.

An example from one of your 6500 CatOS switches. You need to look at the first line of output and under the Status column. In this example it says "connected".

DC-BBP-F00-AS3> (enable) sh port 2/10

* = Configured MAC Address

Port Name Status Vlan Duplex Speed Type

----- -------------------- ---------- ---------- ------ ----- ------------

2/10 RTPR02D connected 190 full 100 10/100/1000

Port AuxiliaryVlan AuxVlan-Status InlinePowered PowerAllocated

Admin Oper Detected mWatt mA @42V

----- ------------- -------------- ----- ------ -------- ----- --------

2/10 none none - - - - -

Port Security Violation Shutdown-Time Age-Time Max-Addr Trap IfIndex

----- -------- --------- ------------- -------- -------- -------- -------

2/10 disabled shutdown 0 0 1 disabled 222

Port Num-Addr Secure-Src-Addr Age-Left Last-Src-Addr Shutdown/Time-Left

----- -------- ----------------- -------- ----------------- ------------------

2/10 0 - - - - -

HTH

Jon

Community Member

Re: CATOS port disable dquestion...

Thank you very much, dont I feel like a fool. I was heading down the wrong road on this one, you cleared it up, thanks again Jon.

1584
Views
5
Helpful
2
Replies
CreatePlease to create content