Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CatOS to IOS on 6509

I need to convert our config on the 6509 from CatOS to IOS. Have anyone used the Cisco EDI CatOS to IOS configuration Tool? Is it worth using it or should I just do this conversion manually? Any suggestions what to look out for would be greatly appreciated. I have never done this before so any advise would be great.

WS-C6509 Software, Version NmpSW: 8.3(4)

System Bootstrap Version: 8.1(3)

System Boot Image File is 'bootflash:cat6000-sup720k9.8-3-4.bin'

cat6509> (enable) sh module

Mod Slot Ports Module-Type Model Sub Status

--- ---- ----- ------------------------- ------------------- --- --------

1 1 24 1000BaseX Ethernet WS-X6724-SFP yes ok

2 2 48 10/100BaseTX Ethernet WS-X6148-45AF yes ok

3 3 48 10/100/1000BaseT Ethernet WS-X6548-GE-TX yes ok

5 5 2 1000BaseX Supervisor WS-SUP720-BASE yes ok

15 5 1 Multilayer Switch Feature WS-SUP720 no ok

6 6 2 1000BaseX Supervisor WS-SUP720-BASE yes standby

16 6 1 Multilayer Switch Feature WS-SUP720 no standby

7 7 8 Network Analysis Module WS-SVC-NAM-2 no ok

8 8 8 Intrusion Detection Mod WS-SVC-IDSM-2 yes ok

9 9 6 Firewall Module WS-SVC-FWM-1 no ok

1 REPLY
New Member

Re: CatOS to IOS on 6509

I have converted 16 6509's using the manual documentation, and in the beginning had problems, mostly because I went out of sequeunce by reading to far ahead. Then configured each module. You have several modules installed that I didn't have, so it might be more time consuming and open to errors using the manual approach.

I realize this might not be the answer your seeking, but I found for our configuration, manual was better, and longest conversion took 30 minutes.

Dave

316
Views
0
Helpful
1
Replies
CreatePlease to create content