03-16-2007 12:57 AM - edited 03-05-2019 02:57 PM
I am going for change of CatOS to Native IOS on my 6509 switch .After conversion of my config , is there anymore activity which i should plan for ?
regards
Neo
03-16-2007 01:10 AM
Hi Neo,
Once you are done with the conversion of code and config from CATOS to NATIVE IOS you are good to go.
If you have 2 sups in your chassis then you can plan for redundancy between your sups using rpr or rpr+ or sso if you have sup 720.
HTH
Ankur
*Pls rate helpfull post
03-16-2007 06:47 PM
Hi Neo,
The link below explains the step-by-step procedure on System Software Conversion from CatOS to Cisco IOS for Catalyst 6500/6000 Switches:-
http://www.cisco.com/warp/customer/473/81.html
Hope this helps!
Best Regards,
Sunny.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide