Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CatOS to Native IOS

I am going for change of CatOS to Native IOS on my 6509 switch .After conversion of my config , is there anymore activity which i should plan for ?

regards

Neo

2 REPLIES
Cisco Employee

Re: CatOS to Native IOS

Hi Neo,

Once you are done with the conversion of code and config from CATOS to NATIVE IOS you are good to go.

If you have 2 sups in your chassis then you can plan for redundancy between your sups using rpr or rpr+ or sso if you have sup 720.

HTH

Ankur

*Pls rate helpfull post

New Member

Re: CatOS to Native IOS

Hi Neo,

The link below explains the step-by-step procedure on System Software Conversion from CatOS to Cisco IOS for Catalyst 6500/6000 Switches:-

http://www.cisco.com/warp/customer/473/81.html

Hope this helps!

Best Regards,

Sunny.

237
Views
5
Helpful
2
Replies
CreatePlease login to create content