I am having terrible luck getting 2 seperate HP blade enclosures to trunk with 4507R's via fiber. Both of my blade enclosures have 2 CBS3020's inside. On one enclosure I was able to get one of the switches to trunk with the 4507R over fiber, but the other link still shows down/down on the 4507 end.
On the CBS3020 end I see it as connected, and the switch is incrementing it's output counters on the interface, but on the 4507 the link is down/down.
The Trunk Failover feature allows rapid failover to the redundant switch. The Trunk Failover feature allows rapid failover to the redundant switch in the blade enclosure if all uplinks from the primary switch fail
If you want to know more please click the following link:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...