First time poster, I know a lot of people ask this question about what to get and so on and so forth,
But currently I have a new job and am looking to get to a CCNP for routing and switching, in the path of CCENT >CCNA > CCNP. I have at home a 3750 Switch, two 2811 Routers(Both from work, and could get a third if needed). What else do I need? On top of that I live in a small apartment, so I would like to get a nice Rack mount for not to much money if possible. I don't want to spend much more than 400 on everything else from here.
I just hate GNS3. I always seem to have issues with it. And it seems like once one of the routers has something go wrong with it the whole thing breaks. I would prefer to work on the hardware just as more of a intro of getting used to everything.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...