01-19-2009 04:03 AM - edited 03-06-2019 03:30 AM
Hello,
I have a Cat3560 connected to Cat6506 (by trunk) and when I execute show CDP neigh too many entries are displayed in the same port (ten0 / 1 = uplink port) what is the meaning?
VIDER01A#sh cdp neigh
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone
Device ID Local Intrfce Holdtme Capability Platform Port ID
VIMI01A Ten 0/1 141 S I WS-C3560E Ten 0/1
VIECO02A
Ten 0/1 140 S I WS-C3560E Ten 0/1
BIBLIOTECA
Ten 0/1 166 R S I WS-C6509 Ten 1/7/13
VIIND04A
Ten 0/1 154 S I WS-C3560E Ten 0/1
VITEL01A
Ten 0/1 170 S I WS-C3560E Ten 0/1
VIMAR02A
Ten 0/1 167 S I WS-C3560E Ten 0/1
VIDER03A
Gig 0/7 155 S I WS-C2950G Gig 0/1
VIHUM01A
Ten 0/1 123 R S I WS-C3560E Ten 0/1
VIDER02A
Gig 0/6 144 S I WS-C2950G Gig 0/1
VIDER01B Gig 0/5 163 S I WS-C2950G Gig 0/1
VIDER04A
Gig 0/8 3 S I WS-C2950G Gig 0/1
thanks.
01-19-2009 04:34 AM
Hi
I think there is atleast one HUB between the devices.
Thanks
Mahmood
01-19-2009 04:56 AM
Hi,
All devices that Cat3560 see through the port Ten0/1 (CDP entries in port Ten0/1) are joined to the same module in cat 6506 (WS-X6716-10GE)
thanks
01-19-2009 05:27 AM
Hi,
All devices that Cat3560 see through the port Ten0/1 (CDP entries in port Ten0/1) are joined to the same module in cat 6506 (WS-X6716-10GE)
thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: