Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CDP neighbour issue

Dear Team,

 

We have connected ASR 1004 to Catalyst 6500 switch.

The interface connected to ASR is coming up and ASR is seen in CDP neighbor of switch but we are unable to ping the ASR.

In ASR we were unable to even  see Catalyst 6500 in CDP neighbor details. Kindly do advise on this.

 

We are using 10Gig SFP module on both sides.

 

Regards,

Avinash

2 REPLIES
Hall of Fame Super Silver

Avinash You have given us a

Avinash

 

You have given us a description of the problem but not much information to work with. You say that the ASR does not see the Catalyst as a CDP neighbor. But we can not be sure if CDP is actually running on that interface. And we are not sure what is the state of the interface on the ASR. Perhaps if we have some additional information we might be able to identify the issue. Can you post the output of these commands on the ASR:

show cdp interface

show interface <ASR_interface>

show arp

 

HTH

 

Rick

New Member

Rick, CDP has been enabled in

Rick,

 

CDP has been enabled in the interface and everything is fine in interface level.

We are using XENPAK-10GB-SR+ in 6500 side and XFP-10G-MM-SR in ASR 1004.

Whether there is any compatibility issues between these connectors?

 

Regards,

Avinash

77
Views
0
Helpful
2
Replies