Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cdp neighbour shows the same switch as neighbour and the connected switch

 

Hi

I have a problem here , cdp neighbor  shows the same switch as the neighbor and the real connected switchh . I know it will show only the real connected switch if i shut and no sh . What i just want know is it a symptom for something else 

 

Dist#sh cdp neighbors   Gig 10/10       
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
                  S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone,
                  D - Remote, C - CVTA, M - Two-port Mac Relay

Device ID        Local Intrfce     Holdtme    Capability  Platform  Port ID
Sw1
                 Gig 10/10        130              S I   WS-C3560- Gig 0/3
Dist
                 Gig 10/10         156             R S I  WS-C6513    Gig 10/10

 

Thank you

3 REPLIES
New Member

I have seen this when a layer

I have seen this when a layer 1 device (hub) was inline somewhere between the switches.

New Member

After i did shut and no shut

After i did shut and no shut it is ok 

New Member

HI,Did you did shut and no

HI,

Did you did shut and no shut in the interface. ?

Is it working fine.?

is it fiber connected cable connected with these devices ?

Regards,

Gurudath K S

 

119
Views
5
Helpful
3
Replies
CreatePlease to create content