Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CDP on ASA 5510

hallo,

How can i ENABLE CDP on ASA 5510.

thx

1 ACCEPTED SOLUTION

Accepted Solutions

Re: CDP on ASA 5510

CDP is not supported on ASA or PIX. What you can do is speak to cisco about it if you need it. maybe they can make it available on the next ASA software version.

Please rate if this helps.

Franco

5 REPLIES

Re: CDP on ASA 5510

Hi,

AFAIK CDP is enabled by default on all cisco platforms.You can enable it manually in global config mode with following command:

Router(Config)#cdp run

But in case of ASA it is not enabled by default(In my knowledge).Also it depends on the Software version you are running.

Please chk this URL:

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/index.htm

HTH,

regards,

shri :)

New Member

Re: CDP on ASA 5510

I was try everything but with no success.

any other suggestions?

thx

Re: CDP on ASA 5510

CDP is not supported on ASA or PIX. What you can do is speak to cisco about it if you need it. maybe they can make it available on the next ASA software version.

Please rate if this helps.

Franco

New Member

Re: CDP on ASA 5510

thank you so much

regards

Re: CDP on ASA 5510

you are welcome.

Franco

15867
Views
15
Helpful
5
Replies
CreatePlease to create content