Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CE 500 Port Configuration

Hi All,

I have the following set-up(see attachment). All the ports are in trunk mode and have the same native vlan. But i can't remotely access switch B from my PC.

I 've tried to resolve the problem by putting the Fa 0/1 port in the router mode but it didn't change a thing.Th switch remained inaccesible.

Can someone give some tips to help me solve the issue?

Thanks.

7 REPLIES
Purple

CE 500 Port Configuration

Hi,

leave the port as L2 port and configure an interface vlan with an ip address on the device.

interface vlan x

ip address x.x.x.x

that's all you've got to do if the pc is in same subnet as your vlan interface.

Regards.

Alain.

Don't forget to rate helpful posts.
New Member

CE 500 Port Configuration

Hi Alain,

it's worth while noting that I can access Switch A and the CE 500 remotely (that is through SSH  and Telnet) but not switch B so i have the feeling that is has something to do with the configuration of the CE 500.

Regards.

Julie

CE 500 Port Configuration

Hi Julie,

Can you ping switch B? If yes are you sure you have enabled ssh and/or telnet and management access is accesible by the PC's network on switch B? If yes please provide sanitized config of ce500 and switch B.

Best regards,

Alex

New Member

CE 500 Port Configuration

Hi Alex,

I can't ping B. SSH and Telnet + Access Management has been configured on B. The management of all switches is 10. Ports Gi 0/1, Gi 0/2 and Fa0/1 of the CE 500 are all in native vlan 10. The ports to which the CE 500 connect to on A, B and C have as native vlan 10.

Best Regards.

Julie

Purple

CE 500 Port Configuration

Hi,

can you provide output of followings on B:

-sh ip int brief | i Vlan

- sh int trunk

-sh int  x/x status

-sh int x/x switchport  where x/x is port connected to CE500

-Does sh ip arp shows the PC mac address?

Regards.

Alain.

Don't forget to rate helpful posts.

CE 500 Port Configuration

Ok, if you try to connect from switch C command line not from the PC to switch B what is the result?

Best regards,

Alex

Purple

CE 500 Port Configuration

Hi Julie,

Oups sorry I misread the original post.

Regards.

Alain.

Don't forget to rate helpful posts.
380
Views
0
Helpful
7
Replies