Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CE 500 & Vista

Hello all,

Can I setup a CE500 using Windows Vista?

Thanks for your help!

Becky

2 REPLIES
Silver

Re: CE 500 & Vista

Last few months back, I researched about the compatibility issues between Windows Vista and CE500 but could not find anything that could point towards the root cause of the issue. However I think if you are able to get an IP address / configure the switches (CE500) with Windows XP computer and not with Windows Vista, there could be an issue with Windows Vista computers internal setting regarding DHCP. This issue occurs because of a difference in design between Windows Vista and Microsoft Windows XP Service Pack 2 (SP2). Specifically, in Windows XP SP2, the BROADCAST flag in DHCP discovery packets is set to 0 (disabled). In Windows Vista, the BROADCAST flag in DHCP discovery packets is not disabled. Therefore, some non-Microsoft DHCP servers cannot process the DHCP discovery packets.

New Member

Re: CE 500 & Vista

Yes, I have this problem with a microsoft DHCP server. I have to change all my vista machines broadcast flag to 0 in order for any clients to authenticate to my open wireless access points.

Regarding vista & ce500 I was unable to configure my switch with vista.

Thanks!

Becky

102
Views
0
Helpful
2
Replies