Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CE500

I have a client that want put the address 10.x.x.x in the vlan1 in a ce500.

How can I avoid this restriction in the ce500.

1 REPLY

Re: CE500

hi

you want to access the switch using the ip address defined by the client, if this is the case then you need to make sure that you are logged onto the switch via the default ip address based on your switch model.

http://www.cisco.com/en/US/products/ps6545/products_configuration_example09186a00806da6c9.shtml

above link helps out in getting logged and configuring the same..

regds

120
Views
0
Helpful
1
Replies