Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

CEF , load balancing , traffic share

Hi everybody

I hope you guys are doing great. I miss this forum a lot, currently I am focused on SP area because of my job which keeps me busy .
Anyway, I have a question; please consider the following example:

 

R1# show ip route

O       4.4.4.4 [110/31] via 16.16.16.6, 00:00:05, FastEthernet0/1
                [110/31] via 15.15.15.5, 00:00:05, FastEthernet0/0


R1#show ip cef 4.4.4.4 internal

4.4.4.4/32, version 33, epoch 0, per-destination sharing
0 packets, 0 bytes
  tag information set
    local tag: tunnel-head
  via 16.16.16.6, FastEthernet0/1, 0 dependencies
    traffic share 1
    next hop 16.16.16.6, FastEthernet0/1
    valid adjacency
  via 15.15.15.5, FastEthernet0/0, 0 dependencies
    traffic share 1
    next hop 15.15.15.5, FastEthernet0/0
    valid adjacency

output omitted!!

++++++++++++++++++++++++++++++

Above we see traffic share is 1, how can we configure traffic share 2  for FastEthernet0/1 ?
I tried manipulating bandwidth under f0/1 but the it seems to have no effect.


I appreciate your help

Have a great weekend.

 

1 ACCEPTED SOLUTION

Accepted Solutions

Since you use ospf traffic

Since you use ospf traffic share will be always (except possibly when combined with MPLS TE) 1.

 

 

1 REPLY

Since you use ospf traffic

Since you use ospf traffic share will be always (except possibly when combined with MPLS TE) 1.

 

 

91
Views
0
Helpful
1
Replies
CreatePlease to create content