Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CEF per-destination load-sharing on Catalyst 6513 switch

Hi all,

I've read that CEF per-destination load sharing is enabled by default on the 6500 switches. What global commands enables this ? Is there an 'interface' command needed as well?

Here's the details of the switch

IOS (tm) s72033_rp Software (s72033_rp-PK9SV-M), Version 12.2(17d)SXB5, RELEASE SOFTWARE (fc1)

1 24 CEF720 24 port 1000mb SFP WS-X6724-SFP

2 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX

3 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX

4 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX

5 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX

6 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX

7 2 Supervisor Engine 720 (Active) WS-SUP720-3B

8 2 Supervisor Engine 720 (Hot) WS-SUP720-3B

9 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX

Thanks,

Mike

5 REPLIES
Blue

Re: CEF per-destination load-sharing on Catalyst 6513 switch

Mike:

In global config mode:

ip cef

ip cef distributed (if there are DFC daughter cards on the line cards)

HTH

Victor

New Member

Re: CEF per-destination load-sharing on Catalyst 6513 switch

Thanks Victor,

Is there anything needed within an interface configuration?

-Mike

Blue

Re: CEF per-destination load-sharing on Catalyst 6513 switch

NO. Any interface that supports CEF will autonatically begin CEF switching once you configure it globally.

HTH

If so, kindly rate my posts.

Thanks

victor

New Member

Re: CEF per-destination load-sharing on Catalyst 6513 switch

Thanks again for the info, Victor.

-Mike

Blue

Re: CEF per-destination load-sharing on Catalyst 6513 switch

You got it, buddy. Post here anytime.

Victor

151
Views
5
Helpful
5
Replies
CreatePlease to create content