Hello, I just copied and pasted a config on to an 887 router.
The original config had the router's certificate visible as per normal i.e. line after line of incomprehensible code near the start of the config, like you always expect to see.
I did not want that cert, so I omitted that from the config I pasted in to the 887. Then to create a new certificate I ran the command 'crypto key generate rsa general-keys modulus 2048'. This obviously created a new certificate as I can SSH into the router without problem.
The thing that is puzzling me is how come I cannot see the certificate in the new config i.e the many lines of certificate code that you would normally see.
Why are all these lines of certificate code not visible now ?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...