Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Change configuration on Catalyst 3560

Hi,

I have an a switch 3560 with IOS c3560-ipbase-mz.122-35 where from port fa 0/1 until port fa 0/22 thera are connected

22 AP Cisco 1242.

On this ports I have configured only "switchport access vlan 3", which is vlan for wi-fi.

Yesterday, for each of this ports I have found:

switchport nonegotiate

switchport mode trunk

switchport trunk encapsulation dot1q

mls qos trust cos

auto qos voip trust

spanning-tree bpduguard enable

and was impossible reach AP and my guest could not surf on Internet.

What can be happen ?

Why did switch change configuration ?

Best regards

Lorenzo

2 REPLIES
Hall of Fame Super Silver

Re: Change configuration on Catalyst 3560

Hello Lorenzo,

have you deployed autoQoS recently?

but I would not expect a change of switchport mode.

one possibility is: someone applied a wrong interface range in an attempt to configure some ports as trunk that included these ports

if the device is under TACACS+ you can check the commands applied to the switch to verify if commands have been added in some way.

Hope to help

Giuseppe

New Member

Re: Change configuration on Catalyst 3560

Thank you Giuseppe

with your answer I have understood

that's impossible to change configurations itself.

best regards

Lorenzo

363
Views
0
Helpful
2
Replies
CreatePlease login to create content