Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Change http password

I have the telnet and enable password for my C2950 switch, but I can't access it through http with the admin username. How can I change the http password used for that protocol by logging on the switch through telnet ?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Change http password

http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_22_ea9/release/notes/OL11484.html

The HTTP server interface must be enabled to display the device manager. By default, the HTTP server is enabled on the switch. Use the show running-config privileged EXEC command to see if the HTTP server is enabled or disabled.

Configure the HTTP server interface for the type of authentication that you want to use.

•enable-Enable password, the default method of HTTP server user authentication.

•local-Local user database, as defined on the Cisco router or access server.

•tacacs-TACACS server.

1 REPLY

Re: Change http password

http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_22_ea9/release/notes/OL11484.html

The HTTP server interface must be enabled to display the device manager. By default, the HTTP server is enabled on the switch. Use the show running-config privileged EXEC command to see if the HTTP server is enabled or disabled.

Configure the HTTP server interface for the type of authentication that you want to use.

•enable-Enable password, the default method of HTTP server user authentication.

•local-Local user database, as defined on the Cisco router or access server.

•tacacs-TACACS server.

297
Views
0
Helpful
1
Replies
CreatePlease to create content