Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Change redundant sup to active.

In CatOS there used to be a command "change sup" which would make the redundant supervisor module active. Does anyone know the equavilant command in IOS 12.2?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Change redundant sup to active.

Hello roland,

did you try :

Router# redundancy force-switchover

Conducts a manual switchover to the redundant supervisor engine. The redundant supervisor engine becomes the new active supervisor engine running the new Cisco IOS image. The modules are reloaded and the module software is downloaded from the new active supervisor engine.

The old active supervisor engine reboots with the new image and becomes the redundant supervisor engine.

Hope this helps.. all the best. rate replies if found useful..

Raj

2 REPLIES

Re: Change redundant sup to active.

Hello roland,

did you try :

Router# redundancy force-switchover

Conducts a manual switchover to the redundant supervisor engine. The redundant supervisor engine becomes the new active supervisor engine running the new Cisco IOS image. The modules are reloaded and the module software is downloaded from the new active supervisor engine.

The old active supervisor engine reboots with the new image and becomes the redundant supervisor engine.

Hope this helps.. all the best. rate replies if found useful..

Raj

New Member

Re: Change redundant sup to active.

that worked great thanks!

148
Views
0
Helpful
2
Replies
CreatePlease login to create content