Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Change the boot var

Hi

I am facing a issue with a MSFC card.

When i enter the boot statement as below

boot system flash bootflash:<image name> and when i see the output using show boot it displays the image name which i specified in the above statement appended to the existing image.

And when i remove the boot statements for which the other files are specified it doesnt modifies the bootvar.

Kindly advice how can i change the bootvar.

Thanks

Mahmood

2 REPLIES
Bronze

Re: Change the boot var

Hi,

Have you saved the running config? The bootvar isn't updated until you "copy run start"

Regards

Re: Change the boot var

Can you post the output of your commands?

320
Views
0
Helpful
2
Replies