cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
689
Views
0
Helpful
2
Replies

Change the boot var

mahmoodmkl
Level 7
Level 7

Hi

I am facing a issue with a MSFC card.

When i enter the boot statement as below

boot system flash bootflash:<image name> and when i see the output using show boot it displays the image name which i specified in the above statement appended to the existing image.

And when i remove the boot statements for which the other files are specified it doesnt modifies the bootvar.

Kindly advice how can i change the bootvar.

Thanks

Mahmood

2 Replies 2

JamesLuther
Level 3
Level 3

Hi,

Have you saved the running config? The bootvar isn't updated until you "copy run start"

Regards

jimmysands73_2
Level 5
Level 5

Can you post the output of your commands?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco