Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Changes to ZFW requiers reload to take effect?

Hi,

I'm relativily new to the IOS ZWF, and have spend a lot of time to figure out why my configs didn't work, and by mistake a router reloaded and every think worked perfectly.

My question is, if it's really nessary to reload every time you make a small change/addition to e.g.. a class-map?

I've tried to remove and re-apply the zone-member on the interfaces, and do shut and no shut, but only reload works.

Another way than reload is appreciated.

Regards, Jorgen Dam

Everyone's tags (3)
2 REPLIES
Bronze

Re: Changes to ZFW requiers reload to take effect?

Hello,

As far as I know and from the configurations I have implemented, a reload is not needed to apply changes on ZFW.

Could you please tell me what configuration did you applied and what was not working before the reload?

Regards.

New Member

Re: Changes to ZFW requiers reload to take effect?

Hi, I have been posting the same question to the Firewallling discussion group, because I thought that this perhaps was the wrong group.

The solution was a bug in IOS v. 15.0.1M2, and every thing worked fine after upgrade to 15.1.0T

But thanks for your reply.

PS. is there a way to close a discussion if the author solves the question/problem him self? I don't have the "Correct Answer" button on my own feeds.

Regards.

294
Views
0
Helpful
2
Replies
CreatePlease to create content