Is there a command to explicitly change the BOOT variable for the redundant supervisor?
My active sup is running catos 8.4.4 and the redundant is running 7.4.3. The BOOT var on the active says run 8.4.4 and the BOOT var on the redundant says run 7.4.3. So I'm getting what I asked for I suppose.
I want to run 8.4.4 on the redundant sup and the image is in the redundant sup bootflash. To make the redundant sup run 8.4.4 after a reset I guess I need to modify the BOOT var for the redundant sup.
Any suggestions how I can modify the the BOOT var for the redundant sup?
A related question: I know that 8.4.4 is in the redundant sup bootflash because it showed up when I ran show flash 2/bootflash: (redundant sup in slot 2) . But now whenever I run the same command I get an error message saying File system in use (5). Try again later.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...