there was a leased line 256kbps connecting two remote sites with serial interfaces. Today the leased line replaced with a fiber optic cable. the one serial interface remains on the side and the other side the Fiber ending into a switch converted to copper.
If we connect that ethernet cable into a routers ethernet interface is there any problem , is there any need of encapsulation protocol?that router leads to internet .
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...