Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

channel-group mode for VSS MEC link to WLC

Hello

I have a Cisco 5508 WLC with LAG enabled - this LAG connects to a single VSS chassis (VSS etherchannel mode is "on" as per the WLC documentation)

I'm looking to spread this LAG across both the VSS chassis - Cisco's VSS best practice document below states that for Multi Chassis Etherchannel "Do not use on and off options with PAgP or LACP or Trunk protocol negotiation"

http://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-virtual-switching-system-1440/109547-vss-best-practices.html

Is anyone else connecting a WLC LAG to a VSS MEC and if so what channel-group mode are they using?

Thanks
Andy

1 REPLY
VIP Super Bronze

Hi,I have never connected a

Hi,

I have never connected a WLC to VSS, but WLC should be threaded just as an access switch and use LACP or PAgP to connect to both VSS switches.

HTH

148
Views
0
Helpful
1
Replies
CreatePlease login to create content